Works but needs calibration

Test drive works good

Changed oil and oil filter. New locking mechanisms (x2) for the hatch to the engine compartment, 1 better used welding beam (modified), New welding wires and tape on the welding beams, New connectors to the welding beam New rubber seal for the lid, New screen part, Aligned the lid, Changed tires,

New air hoses, New air bellows, New Teflon tape, Changed the order of the belts, 2 new potentiometers, Changed the input air pressure regulator, New oil in the vacuum pump, New silicone strips under the welding beams, 1 new switch for emergency stop, Renovated/cleaned vacuum and pressure valve.

New gaskets and bearings in the gearbox. New pedal New grinding wedge New emergency stop

Replaced a position sensor for the trough holder. Replaced the phase sequence monitor. Cleaned the throttle valve for the cooling water. Repaired the locking of the door on the back. Changed the oil in the vac pump. Cleaned the air filter for the vac pump.

Test drive works fine!

Test run works fine

Tested, works well!

Renovated outer drive unit agitator. Changed oil in vac pump. Changed oil in gearbox. Lubricated funnel bearing. Test driven, among other things.

Directional carriage control, New 3-way valve, New solenoid valve. Heats, steams and regulates as it should! Lamps out of order in the oven.