Rep circuit board in frequency converter. Built brackets and fixed electrical cabinet. New feeder cable ATTENTION! After a power failure, the lift must be reset with an emergency stop. And you should drive at low speed towards the end positions. Two speeds. Works perfectly

Newly painted hydraulic tank and engine Tub width: 100cm Tub depth: 75cm Lifting height: 110cm

Test driven, good condition!

Test driven, new condition!

New addition New glove Works well

New gaskets and bearings in the gearbox. New pedal New grinding wedge New emergency stop

Test drive goes quietly and nicely 👍

New start button, new contactor and new motor protection, New radial seal for the grinder part and new shaft seal in the mixer part, Directional plates, New foot pedal, New tooth for the starting mechanism for the grinder, New power cable and connector, New lid switch

Test run works well. Screw and mill pin in good condition

Manufactured new mill wedge Mounted door switch

New foot pedal installed. New relay and engine protection. Otherwise very good condition.