New bearing for the fan.

New water inlet and replacement of solenoid valve.

Works fine otherwise

Test run OK

Change the emergency stop Review Works well Max product height 10cm

Newly painted hydraulic tank and engine Tub width: 100cm Tub depth: 75cm Lifting height: 110cm

New band test run works Must be calibrated when installing detecttronic technician Product height Max 14cm

Test run OK 100kg capacity jaws: 60x40cm

Refurbished feed screw, new bearing bottom part plastic New seals lids and hatches Repaired band New button covers -No vibrator

Refurbished lifting device for cleaning. Measured and checked the condition of heating rods, 7pcs heating rods replaced with new. Power heating rods: 4500 watts x12 Dimensions: 530x150cm Belt: 60cm Internal measurement for product: 400x60cm. Adjustable belt speed.

With oil container 1100liter
Electric cartridges, thermostat and float tested, work well.

Outer dimensions: 230x110cm, height 195cm

Fixed function lever for grinding Manufactured / modified cutter New springs cover 2 pcs New wheels 4 lockable New bearings and seals in mill house drive New screw pin

Test run and adjusted welding times Works well Tube dimension: 156mm Welding width: 25cm Front cup missing, sensor bridged

Fixed the hatch New tensioner for the hatch The machine uses central vacuum and central cooling. Vacuum and cooling chamber pressure tested and are tight.

Offered with or without control cabinet and transformer.

Replace front bearing

Replace p-box motor

Mesta el utbytt

Renovered tensioner

Front cover could not be repaired; lock switch.

Test drive works fine. With adjustable speed, "down" A phase Height: 140-185cm

Description Year model 2005 A tool for 2 pcs 195×125 troughs 230 volt 16 amp 2000w

Only Gas

Smoke cabinet from Protech. Runs with liquid smoke

Model: FGM 20/80 F 1.1 kW

Capacity: 100kg Tray: 60x40cm Lifting height approx: 65cm Air pressure: 6bar

Function check, everything works as it should.

Complete renovation Replace a beam 100x40 Repacked piston plus painted up Built new bracket hydraulic pump Manufactured protection for pump Fitted adjustable feet Container dimensions: 85x109cm, height 92cm Total dimensions: 145x175cm, height 220cm

Cleaned electrical cabinet Change the main switch Switch buttons in remote control New bearings + packing box in drive shaft New bearings + packing box in engine Test driven

Test run OK

New bearing front wheels. Tensioner refurbished Fixed the electrical box Installed water connections.

Rep circuit board in frequency converter. Built brackets and fixed electrical cabinet. New feeder cable ATTENTION! After a power failure, the lift must be reset with an emergency stop. And you should drive at low speed towards the end positions. Two speeds. Works perfectly

Kolb/Atollspeed GC-3070 works fine. Requires 10min preheating

Test driven, good condition!

New thumb guard

New saw blade

New blade guard

Better start scraper

New bearings on the intermediate shaft Please watch the video

New packing boxes New gasket between machine and tub Works fine Grain mill 98mm, 2 knives

Getinge M3 Stew Pot New valve packages Model year 2009