New bearing for the fan.

New water inlet and replacement of solenoid valve.

Works fine otherwise

Newly painted hydraulic tank and engine Tub width: 100cm Tub depth: 75cm Lifting height: 110cm

Change the emergency stop Review Works well Max product height 10cm

New band test run works Must be calibrated when installing detecttronic technician Product height Max 14cm

Refurbished lifting device for cleaning. Measured and checked the condition of heating rods, 7pcs heating rods replaced with new. Power heating rods: 4500 watts x12 Dimensions: 530x150cm Belt: 60cm Internal measurement for product: 400x60cm. Adjustable belt speed.

With oil container 1100liter
Electric cartridges, thermostat and float tested, work well.

Outer dimensions: 230x110cm, height 195cm

Fixed the hatch New tensioner for the hatch The machine uses central vacuum and central cooling. Vacuum and cooling chamber pressure tested and are tight.

Refurbished feed screw, new bearing bottom part plastic New seals lids and hatches Repaired band New button covers -No vibrator

Complete renovation Replace a beam 100x40 Repacked piston plus painted up Built new bracket hydraulic pump Manufactured protection for pump Fitted adjustable feet Container dimensions: 85x109cm, height 92cm Total dimensions: 145x175cm, height 220cm

Test run OK 100kg capacity jaws: 60x40cm

Cleaned electrical cabinet Change the main switch Switch buttons in remote control New bearings + packing box in drive shaft New bearings + packing box in engine Test driven

Test run OK

Test run OK

Description Year model 2005 A tool for 2 pcs 195×125 troughs 230 volt 16 amp 2000w

Only Gas

Smoke cabinet from Protech. Runs with liquid smoke

Capacity: 100kg Tray: 60x40cm Lifting height approx: 65cm Air pressure: 6bar

Function check, everything works as it should.

Welded and milled arms for the counterweights and arranged locking mechanism for the axles, Sealed all possible sources of leakage with silicone and welded crack in the table. Vacuum value: 6-7mbar both sides

Rep circuit board in frequency converter. Built brackets and fixed electrical cabinet. New feeder cable ATTENTION! After a power failure, the lift must be reset with an emergency stop. And you should drive at low speed towards the end positions. Two speeds. Works perfectly

New air hoses, New air bellows, New Teflon tape, Changed the order of the belts, 2 new potentiometers, Changed the input air pressure regulator, New oil in the vacuum pump, New silicone strips under the welding beams, 1 new switch for emergency stop, Renovated/cleaned vacuum and pressure valve.

New door list

Works fine!

New bearings and seals for the blade shaft. New bearings and seals for the engine scraper. New piston seals for the scraper. Replaced the mechanical tachometer with a new magnetic sensor. Vacuum chamber resealed. Lubricated and cleaned. Newly sharpened blades. New stuffing boxes

Test drive works fine

test run Works well

Test run works. No steam.

SFK-Danfotech MA8001

New starter motor hood

New vacuum gauge

Please watch the video

For more information contact us

New bearings on intermediate shaft

Please watch the video

No protective grate (not approved)

Capacity (Kittel volume):100 liters.

Power output:2 kW.

speed control: Equipped with an electronic system for stepless speed variation.

Material: Heavy and solid construction in cast iron