New bearing in rotor Test run without any complaints Tipping height 174cm

test run Works well

New main switch New buttons New limit switch mechanism New connection cable Mounted protection over chain Test run works well

Tested good working order

Rep circuit board in frequency converter. Built brackets and fixed electrical cabinet. New feeder cable ATTENTION! After a power failure, the lift must be reset with an emergency stop. And you should drive at low speed towards the end positions. Two speeds. Works perfectly

Newly painted hydraulic tank and engine Tub width: 100cm Tub depth: 75cm Lifting height: 110cm

Test drive goes quietly and nicely 👍

Manufactured new mill wedge Mounted door switch

Cleaned electrical cabinet Change the main switch Switch buttons in remote control New bearings + packing box in drive shaft New bearings + packing box in engine Test driven

Replace the air reducer New glove

Tested, works fine!