The machine has been at a school. Very nice condition inside, looks almost new.

Change the thermostat Overhauled, works well

Replaced drive belt, ovehauled and works fine. An optional tool in stock is included with the purchase of the machine. Tools in stock: 5x5, 6x6, 10x10, 12x24mm

Replace end switch Refurbished feed piston

Painted engine and gearbox New side plastic New curtain Works well

Change the oil Stand included Test driven, very good condition Includes tray, plastic, gas clock and gas meter. Tray: 14x21cm

Change the oil Replace welding tape Change silicone strip Replace lid seal Vacuum value 7

Tub dimensions: width 100cm, height 90cm Conveyor belt 210x50cm

Test run OK Variable lifting height 140-200cm

Renovated the buttons Fixed hydraulic system Replace sensor

Frying /Fryer/Cooking - top condition! Barely used, has been in warm storage. "With VarioCooking Center MULTIFICIENCY®, Frima VCC you can cooking, roasting, roasting, low-temperature cooking, confectionery, sous-vide cooking... without supervision, without burning, without the stress of handling pots and pans."

Test drive and review Works perfectly

Replace air distributor Replace welding tape Change the oil Fixed connectors for pinch protection Double weld + cut off

Refurbished output shaft gearbox. New packing box mill house. New button rubbers. New emergency stop. Painted inside.

Change one sensor

Repaired locking to mill house Note: Missing lid switch and motor protection

Testrun good working order

Test run OK Band saw blade 2845x19mm Extra large table: 70x115cm

New input and output bands New knife Works perfectly

The machine is used for fixed-weight slicing. Roast beef, roast ham, roast turkey, pork tenderloin etc. The machine scans the product and calculates the exact weight of each disc with double check scales. You can divide the weight into different parts of the meat, 300g first slice of a beef filet, divide the middle into 200g slices and leave the tail. The machine has only run 1000 hours. Serviced by Treif.

Cleaned electrical cabinet Change the main switch Switch buttons in remote control New bearings + packing box in drive shaft New bearings + packing box in engine Test driven

Mounted cutoff on-off Replace main power switch Renovated welding beam The machine runs with an external vacuum pump or central vacuum (pump not included, can be purchased separately) Welding beam: 80x70cm The conveyor belt is included

Changed two air cylinders. Adjusted cadence sensor. Refurbished safety switch. Change the main switch.

Replaced packing boxes in the mixer gearbox Welded mixer arm Fixed bushing for mixer arm Painted engines and gearboxes

Test run OK Product height 13cm

Test run OK

Test run and adjusted welding times Works well Tube dimension: 156mm Welding width: 25cm Front cup missing, sensor bridged

Offered with or without control cabinet and transformer. Replace front bearing Replace p-box motor Most electricity replaced Refurbished tensioner

Vacuum filler: Replace mini relay for lift on circuit board. Change oil+filter in vac pump. Portioner Test driven without remarks. Grinding disc: 1.8mm, 2mm, and 3mm.

Function check without remark New wheels and welded new wheel plates Painted blower motor Directed lattice band New electric glove

Belt width: 630mm